Optional Glass Panel Kits - Jøtul Scan 45i TSI Installation And Operation Instructions Manual

139472_Rev_B 8.28.12
Install Optional Glass Panels
#157269 Mirrored Panels
#157270 Black Reflective Panels
#157271 Black Reflective Panels, Decorative
Kit Contents:
• Left and Right Panels
• Rear Panel
• White Cotton Gloves
Tools Required:
• 1/4" socket driver
• 10 mm socket wrench
CAUTION !
HANDLE THE PANELS USING THE WHITE COTTON GLOVES
SUPPLIED. SKIN OILS CAN ETCH THE GLASS SURFACE AND
FINGER PRINTS CAN BE DIFFICULT TO REMOVE.
1. Remove the glass frame.
2. Lift the Burner Skirt & Tray assembly out of the firebox
as a unit. Tilt the assembly to ease it through the
firebox opening.
3. Lift the right end of the burner up enough to
disengage it from the Burner Bracket and slide it out
from the air shutter. See figs. 14 and 15, pages 16-17.
4. Use a 10 mm socket to remove the left and right
burner bracket nuts. Remove the Burner Bracket from
the firebox. See fig. 23.
5. Bend the two upper rear tabs down enough to
position the rear glass panel behind each and against
the back wall. You will need to first lift the bottom
edge of the glass panel up and over the pilot assembly
and then lift the panel up behind the tabs to seat it on
the back ledge. See fig. 24.
6. Bend the two upper forward tabs down enough to
position the side panels behind them and against the
side walls.
7. Press each retainer tab back up against the glass to
lock the panels in position.
8. Replace the Burner Bracket and secure with the nuts.
9. Replace the Burner within the air shutter and Burner
Bracket. Be sure to engage the burner slot with the
right side of the burner bracket. Properly positioned,
the burner will be immovable from side-to-side.
10. Replace the Burner Skirt and Tray assembly.
11. Replace the glass frame and re-engage the frame
latches.
20
Figure 23. Remove the left and right Burner Bracket nuts.
Figure 24. Left side glass retainer tabs.
Figure 25. Right side glass retainer tabs.