Table of Contents
Advertisement
139177-V GI 450 DVII 11/20
Install Optional Brick Panels
#157220 Boston Buff Beige
Rear Panel
Top Panel
Left Panel
Right Panel
Left Floor Panel
Center Floor Panel
Right Floor Panel
#157221 Chimney Red
Rear Panel
Top Panel
Left Panel
Right Panel
Left Floor Panel
Center Floor Panel
Right Floor Panel
CAUTION !
THE PANELS ARE EXTREMELY FRAGILE. HANDLE GENTLY.
BEING CAREFUL TO AVOID DAMAGING THE EDGES FROM
CONTACT WITH OTHER PARTS OF THE FIREPLACE.
1. Remove the two cast iron side panels from the
firebox. Use a 10 mm socket wrench to remove the
retainer brackets located at the rear corner of each
panel, as shown at right. The panels will not be
reinstalled, however YOU MUST REPLACE THE M6
BOLTS IN THOSE LOCATIONS. Fig. 20
2. Use the 10 mm socket wrench to remove the two
Grate assembly M6 flange head hex nuts located
behind the grate crossbar. Remove the Grate as-
sembly from the firebox and set aside. Figs. 21 -22.
3. Remove the burner tube by lifting it slightly and
sliding it to the right to disengage it from the ain-
inlet shutter.
4. Set the Floor panels into place in the firebox, being
careful to avoid chipping the edges. See fig. 23
5. Place the Brick panels into position in the numeri-
cal order indicated in fig. 24.
Figure 20. Ornamental cast iron panel removal. REPLACE
BOLT IN THE HOLE AFTER REMOVING BRACKET AND PANEL.
20
224167
224168
224169
224170
224171
224172
Tools Required:
224173
• 1/4" socket driver
• 10 mm socket wrench
224177
224178
224179
224180
224181
224182
224183
Figure 21. Remove left side Grate assembly M6 nut...
Figure 22. ... and right side Grate assembly nut.
Left
Floor
Front Floor Panel
Figure 23. Base panel locations.
Right
Floor
Advertisement
Table of Contents
