Setup As Pop3 Client - Panasonic DP-2330 Operating Instructions Manual

Setup as POP3 Client

To install your machine as POP3 Client, the following network parameters need to be programmed on your
network.
• TCP/IP Address of your machine
• TCP/IP Subnet Mask of your machine
• TCP/IP Address of the Default Gateway
• TCP/IP Address of the DNS Server (if not available, see Note 2)
• Email Address of your machine (see Note 1)
• Name or IP Address of the Default SMTP mail server
• POP Server Name or IP Address
• POP User Account Name
• POP Password
Email Transmission (from your machine to a PC)
Email reception (from a PC to your machine)
NOTE
1. The email address format can be the same as your regular email address. If your email
address
Internet_Fax@panasonic.com.
2. By default the machine requires the IP Address of the DNS Server and prompts you to enter
the SMTP and POP Server Names.
If the DNS Server is not available, change the 27(DNS Server Address)(For DP-2330/3030),
26(DNS Server Address)(For DP-3530/4530/6030) of General Settings to "No" .
(For DP-2330/3030)
Press
OK
(For DP-3530/4530/6030)
Press
OK
Then the machine will prompt you to enter the IP Address of the SMTP and POP Servers.
Pre Installation Information
ifaxuser@fax01.panasonic.com
Gateway(Router)
SMTP
POP3
popuser001@panasonic.com
ifaxuser@panasonic.com
Gateway(Router)
SMTP
POP3
popuser001@panasonic.com
is popuser001@panasonic.com,
FUNCTION GENERAL SETTINGS
.
27 DNS Server Address
FUNCTION GENERAL SETTINGS
.
26 DNS Server Address
SMTP01.panasonic.com
(SMTP Mail Server)
POP02.panasonic.com
(POP Server)
SMTP01.panasonic.com
(SMTP Mail Server)
POP02.panasonic.com
(POP Server)
your machine's email address
09 Key Operator Mode
04 Key Operator Mode
can be
, Input ID Code,
, Input ID Code,
109