Table of Contents
Advertisement
Note:
Desktop peripherals, including add-in cards, will not work in mobile power mode. If
desktop peripherals are used, the platform must be powered using desktop power
mode. The AC Brick power supply configuration does not provide the 12 V supply
required by most desktop peripherals.
Note:
Select a power supply that complies with the "ATX12V" 1.1 specification. For more
information, refer to http://www.formfactors.org.
Note:
If the power button on the ATX power supply is used to shut down the system, wait at
least five seconds before turning the system on again to avoid damaging the system.
Other Devices and Adapters: The evaluation board functions much like a standard
desktop computer motherboard. Most PC-compatible peripherals can be attached and
configured to work with the evaluation board.
2.5
Setting Up the Evaluation Board
Once the necessary hardware (described in
steps below to set up the Mobile Intel
Note:
To locate items discussed in the procedure below, please refer to
1. Create a safe work environment.
Ensure a static-free work environment before removing any components from their
anti-static packaging. The evaluation board is susceptible to electrostatic discharge
damage, and such damage may cause product failure or unpredictable operation. A
flame retardant work surface must also be used.
2. Inspect the contents of your kit.
Check for damage that may have occurred during shipment. Contact your sales
representative if any items are missing or damaged.
Caution:
Connecting the wrong cable or reversing the cable can damage the evaluation
board may damage the device being connected. Since the board is not in a
protective chassis, use caution when connecting cables to this product.
Caution:
Standby voltage is constantly applied to the board. Therefore, do not insert or
remove any hardware unless the system is unplugged.
Note:
The evaluation board is a standard ATX form factor. An ATX chassis may be used if a
protected environment is desired. If a chassis is not used, standoffs must be used to
elevate the board off the working surface to protect the memory and to protect from
any accidental contact to metal objects.
3. Check the jumper default position setting. Refer to
Jumper J6H1 is used to clear the CMOS memory. Make sure this jumper is set for
normal operation.
4. Be sure to populate the following hardware on your evaluation board:
— One Pentium
— One processor thermal solution
— One DDR2 SODIMM (200-pin)
Note:
For proper installation of the CPU thermal solution, please refer to
Sink Installation Instructions"
5. Install a SATA or IDE hard disk drive.
6. Connect any additional storage devices to the evaluation board.
7. Connect the keyboard and mouse.
®
Mobile Intel
915GME Express Chipset
Development Kit User's Manual
18
Mobile Intel
®
915GME Express Chipset evaluation board.
®
M 760 Processor
®
915GME Express Chipset —Getting Started
Section
2.4) has been gathered, follow the
Section
Figure 4
for jumper location.
Appendix A, "Heat
Order Number: 317230-001US
4.0.
April 2007
Advertisement
Table of Contents
