Table of Contents
Advertisement
3. Program the H8 via the serial port.
4. Disconnect the power supply from the system.
5. With the board powered off, move the five jumpers listed in
default stuffing option.
Table 11.
H8 Programming Jumpers
#
Jumper
3
1Hz Clock
4
H8 Programming
In-circuit H8
8
Programming
15
Tx Select
16
Rx Select
4.6.2
Expansion Slots and Sockets
Table 12.
Expansion Slots and Sockets
Reference
Designator
U2E1
J5N1
J5P1
J5F1
J6C1
J6C1
J7C2
J8C1
J8D1
J8B1
J9B3
J7J2
J8J3
J7H1
J6H3
U8G1
BT5H1
4.6.2.1
478 Pin Grid Array (Micro-FCPGA) Socket
The pin locking mechanism on the CPU socket is released by rotating the screw on the
socket 180 degrees counter-clockwise. CPU pins are keyed so as to only allow insertion
in one orientation. DO NOT FORCE CPU into socket. Once the CPU is properly seated
®
Mobile Intel
915GME Express Chipset
Development Kit User's Manual
42
Mobile Intel
Reference
Default Stuffing Option
Designator
Out - normal operation -
J9H1
clock enabled
J9J3
OUT - normal operation
J7J1
1-2 normal operation (SIO)
J7A3
1-2 Normal Operation
J7A2
1-2 normal operation (SIO)
Slot/Socket Description
478 Pin Grid Array (Micro-FCPGA) Processor Socket
DDR2 - Channel A - SODIMM slot
DDR2 - Channel B - SODIMM slot
LVDS Graphics Interface
PCI Express (x16)
ADD2-R Slot
PCI Express (x1) Slot 1
PCI Express (x1) Slot 2
PCI Express (x1) Slot 3
PCI 2.3 Slot 1
PCI 2.3 Slot 2
IDE Interface Connector
Mobile SATA Hard Drive Interface Connector
Desk Top SATA Hard Drive Interface Connector
SATA Desk Top Power Connector
Intel Firmware Hub Socket
Battery
®
915GME Express Chipset —Hardware Reference
Table 11
Programming Stuffing
IN - clock disabled - enable H8
programming
IN - enable external H8
programming
2-3 connect TxD to H8 for
programming
2-3 connect TxD to H8 for
programming
2-3 connect RxD to H8 for
programming
Detail
Table 13
Table 14
Table 15
Table 15
Table 15
Order Number: 317230-001US
back to the
Option
April 2007
Advertisement
Table of Contents
