Table of Contents
Advertisement
7. Lubricate the M10 x 178mm Bolt (17). Attach the
Backrest (6) to the Frame (2) with the Bolt, two
M10 Washers (24), and an M10 Nylon Locknut
(19).
Secure the Backrest (6) to the Frame (2) with the
Adjustment Pin (32) through one of the three sets
of holes in the adjustment tubes. Secure the
Adjustment Pin with the Pin Clip (14).
Make sure the Adjustment Pin (32) is com-
pletely inserted through both holes in the
adjustment tubes.
8. With the wide end of the Seat (11) positioned as
shown, attach the Seat to the brackets on the
Frame (2) with four M6 x 16mm Screws (15).
9. Attach the Curl Pad (27) to the Curl Post (26) with
two M6 x 16mm Screws (15).
10. Slide the Curl Post (26) into the Front Leg (8).
Align one of the adjustment holes in the Curl Post
with the adjustment hole in the Front Leg. Tighten
the M10 x 48mm Adjustment Knob (33) into the
adjustment hole in the Front Leg. Make sure that
you fully tighten the Adjustment Knob.
7
32
17ÑLubricate
24
8
11
Wide
End
9
27
10
26
8
6
Adjustment
Tubes
2
14
19
2
15
15
26
8
33
Advertisement
Table of Contents
