Connecting Power (If Required); Configuring The Digital Scanner; Mounting The Digital Scanner - Motorola Symbol DS9808 Product Reference Manual

1 - 4 Symbol DS9808 Product Reference Guide
Follow the steps for
3.

Connecting Power (if required)

If the host does not provide power to the digital scanner, connect an external power supply:
Connect the interface cable to the base of the digital scanner, as described in
1.
page 1-3.
Connect the other end of the interface cable to the host (refer to the host manual to locate the correct port).
2.
Plug the power supply into the power jack on the interface cable. Plug the other end of the power supply into
3.
an AC outlet.

Configuring the Digital Scanner

To configure the digital scanner use the bar codes included in this manual. See
Miscellaneous Digital Scanner Options
digital scanner using bar code menus. Also see each host-specific chapter to set up connection to a specific host
type.

Mounting the Digital Scanner

An optional wall mount bracket is available for mounting the scanner to a wall or other vertical surface. To mount
the Symbol DS9808:
Place the bracket in its desired location on the wall, and insert three #6 screws through each screw hole in the
1.
bracket.
Installing the Wall Mount Bracket
Figure 1-4
Tighten the screws to secure the bracket to the wall.
2.
Installing the Interface Cable
and Chapter 5, Imaging Preferences
to connect a new cable.
Chapter 4, User Preferences &
for information about programming the
Installing the Interface Cable on