Calibration- Old Lcd Display - Keys Fitness Treadmill Service Manual

(LCD) LIQUID CRYSTAL DISPLAY CALIBRATION
1. Unplug power cord for 30 seconds.
2. Remove safety key.
3. Plug in power cord.
4. Push reset button (locate access hole for reset button, located behind console monitor). Insert eraser
end of pencil into the hole and gently press button (shown in figure below). 10 in the SPEED Window.
5. Press ENTER 5 times.
6. Push START button.
7. Push ENTER.
8. Replace Safety Key.
9. Push ENTER button.
10. After calibration is complete, push POWER button three times.
11. Treadmill will turn off on its own.
After electrical re-installation of motor actuator, motor controller or electronics, re-calibration is necessary.
CALIBRATION- LCD DISPLAY
Calibration- LCD Display
OLD
48