Front Roller Removal Procedure
Please follow all steps in sequential order to replace front roller assembly.
You will need the following tools for installation:
7/16" Wrench, Phillips Screwdriver and Allen Wrench (supplied with treadmill).
1. Remove motor cover screws from front of treadmill. See Figure 1.
2 Power up treadmill and set incline to 12%. Unplug power cord from surge protector or wall out-
let. See Figure 2.
Figure 1: Remove Hardware in Motor Cover
Figure 2: Set Incline to 12%
3. Unit should look similar to Figure 3.
4. Remove motor cover from treadmill by lifting straight up as shown in Figure 4.
Figure 4: Remove Motor Cover
Figure 3: Incline Position
5. Unit should look similar to Figure 5.
6. Remove Poly V Belt from front roller assembly by pushing belt over to one side while rotating
belt back and forth. See Figure 6.
Figure 5: Unit without Motor Cover
Figure 6: Remove Drive Belt
59