Samsung SVR-1670 User Manual page 18

Chapter 3. Hardware Installation
5. Connect the SMPS (switched mode power supply) power cable.
A
B
A B
Figure 3.6.5 Connecting SMPS Power Cable (Change the Image)
Figure 3.6.6 The SVR-1670 Connected with Maximum Number of HDDs
6. Close the upper cover on the SVR-1670, and then reconnect all devices that were removed for
the hard drive installation.
Now, it is time to confi gure and activate the hard disk drive.
34
Digital Video Recorder
D
C
C D
SVR-1670
Enabling a Hard Disk Drive
To enable the newly attached hard disk drive, you must change its availability to " O " on the
SVR-1670's Disk Manager menu.
1. From the OSD, select the System Settings menu.
2. Select the Disk submenu and then, select Disk Manager.
- The newly installed hard disk drive appears in the list along with O and X under the State
category.
Figure 3.6.7 Disk Manager Menu Showing Disabled Hard Disk Drive
3. To change to Enabled status, select the hard disk drive to connect and then press ESC to exit
the Disk Selection menu. To enable the hard disk drive, select Add and then press Enter. You
can add the hard disk drive to store data.
Figure 3.6.8 Disk Manager Menu Showing Enabled Hard Disk Drive
Digital Video Recorder
35
SVR-1670