Shaft Link - Oki OKIPAGE 8c Plus Maintenance Manual

3.3.35 Shaft Link

1. Remove the eraser bracket assy. (See 3.3.34.)
2. Remove the gear one-way (Z30). (See 3.3.14.)
3. Remove the E-ring 3 by sliding the sensor assy T (KCM) 1 and bracket sensor T (KCM) 2
together in the arrow (A) direction. When removing shaft (K) assy, remove 3 screws then
remove the Heat Sink-801 B. Release the lock of the claw then remove the plate shield Heat
C by sliding .
Release the engagement between the lever Up/Dn and boss A of the lever link (R) 5 by
4.
sliding the spring support (R) 4, lever link (R) 5 and the bearing 6 together in the arrow (B)
direction.
(Keep on sliding until the lever link (R) 5 reaches the end of D-cut part of the shaft link 7.)
5. Draw out the entire shaft link 7 by pressing it in the arrow (C) direction and turning its left side
under the contact (BL L) assy.
Detach the sensor assy T (KCM) 1, bracket sensor T (KCM) 2, spring support (R) 4, lever
6.
link (R) 5 and the bearing 6 from the shaft link 7.
Remove 2 E-rings 8 then remove the spring support (L) 9 and lever link (L) 0.
7.
[Notice for mounting]
Engagement between the lever Up/Dn and boss A of the lever link (R) 5:
-
Mount the spring support (L) 9 and lever link (L) 0 in the predetermined positions, then clamp
the boss A of lever link (R) 5 with the lever Up/Dn by adding rotating power on the spring
support (L) 9 by rotating the shaft link 7.
- Mounting of the spring support (R) 4:
Clamp the spring support (R) 4 at the predetermined positions in the lever link (R) 5 and the
contact BKT (R).
0
9
8
41057601TH Rev.1
(D)
7
Remove 7
(C)
1
Slide 7
2
3
(A)
Slide 1, 2
3
4
5
(B)
Slide 4, 5 and 6
Figure 3.3.35 Shaft Link
Boss A
Lever Up/Down
Boss A
6
A
Stay EP
C
B
82/