Oki OKIPAGE 8c Plus Maintenance Manual page 121

B C
• No Is the resistance of belt motor about 7.1 ohms?
No
• Yes Check the gear engagement or replace the engine board.
• Yes Check the gear engagement or replace the belt cassette Assy.
• No Does the leading edge of a paper pass by the Exit sensor?
• Yes Is the sensor lever in a normal operation?
• No Replace the defective sensor lever (Exit sensor)
• Yes Is the Exit sensor in a normal operation?
(Operate the sensor lever and check its signal on pins land 6 of the RSENS connector of
the engine board (PX4-PCB).)
• No Check the connection of the signal cable or replace the sensor board (PXL-PCB).
• Yes Replace the engine board (PX4-PCB).
• No Replace the engine board (PX4-PCB).
41057601TH Rev.1
Replace the belt motor.
121/