Step 5 Power On - SOYO SY-KT600 DRAGON Plus User Manual

Hardware Installation
G. CMOS Clear (JP5)
In some cases the CMOS memory may contain wrong data, follow the steps
below to clear the CMOS memory.
1. Put the jumper back to 1-2 to allow writing of new data into the CMOS
memory.
2. Clear the CMOS memory by momentarily shorting pin 2-3 on jumper
JP5. This jumper can be easily identified by its white cap.
CMOS
Clearing
JP5 Setting
Note: You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.

Step 5 Power On

You have now completed the hardware installation of your KT600
DRAGON Plus successfully.
1. Turn the power on.
2. It takes awhile to boot-up to the system. You will hear 3 beeps before
seeing a display on the screen.
3. To enter the BIOS Setup Utility, press the <DEL> key while the system is
performing the diagnostic checks
Note: If you have failed to enter the BIOS, wait until the boot up
sequence is completed. Then push the RESET button and press
<DEL> key again at the beginning of boot-up, during diagnostic
checks.
Retain CMOS Data
Short pin 2-3 for
at least 5
seconds to clear
the CMOS
SY-KT600 DRAGON Plus
Clear CMOS Data
Short pin 1-2 to
retain new
settings
3 2 1
40
3 2 1