Atx Power - SOYO SY-KT600 DRAGON Plus User Manual

Hardware Installation
F. ATX Power Supply
Plug the connector from the power directly into the 20-pin male ATX PW
connector on the motherboard, as shown in the following figure.
Warning: Follow these precautions to preserve your
motherboard from any remnant currents when connecting to
ATX power supply:
Turn off the power supply and unplug the power cord of the
ATX power supply before connecting to ATX PW connector.
If the power supply is powered and connected to the
mainboard the 5VSBLED will light up.
The KT600 DRAGON Plus requires a power supply that is approved by
AMD, of at least 350W. Go to
approved power supply. Make sure the ATX power supply can take at least
720 mA * load on the 5V Standby lead (5VSB) to meet the standard ATX
specification.
SY-KT600 DRAGON Plus
ON
http://www.amd.com
38

ATX Power

5VSBLED
for more info on