SOYO SY-KT600 DRAGON Plus User Manual page 12

Motherboard Description
VIA Apollo KT600 North Bridge
The advanced FastStream64 DDR400 Memory Controller on the
VIA Apollo KT600 interweaves with the 400MHz Front Side Bus
to provide a perfectly balanced subsystem, greatly reducing data
F
latency and enabling searing performance from the latest AMD
Athlon™ XP processors. In addition, the KT600 supports the very
latest I/O technologies including AGP8X, deriving maximum
performance from the most powerful graphics processors.
AGP Slot
This is the AGP expansion slot for your video card. Note that it can
G
only work with 1.5v AGP cards. For more information, check the
Step 3 Installation of Expansion Cards paragraph on page 29.
CPU Cooling Fan (CPUFAN1, 2) connectors
With these connectors you can attach the CPU fan or fans to your
motherboard. They supply power and (in the case of CPUFAN1)
H
allow you to monitor the speed of the FAN via the SOYO
Hardware Monitor software or via CMOS setup. For more details
on the lay-out of these connectors, check the (1) CPU Cooling
FAN (CPUFAN1, CPUFAN2) paragraph on page 33.
DDR DIMM Banks
These 4, 184 pin memory slots are to install your system memory
I
in. They support up to 3GB of memory. For more details check the
Step 2 Install Memory Module paragraph on page 22.
FJ1 FSB Setting Jumper
J
This dipswitch is to set the multiplier of an unlocked CPU. Please
check the FJ1 paragraph on page 16 for more details.
Chassis Cooling Fan (CHAFAN1)
This connector is to connect your chassis fan to your motherboard.
This motherboard supports up to 2 chassis fans. It allows you to
K
monitor the speed of CHAFAN1 in CMOS setup or by using the
SOYO Hardware Monitor software. Please check the (2)Chassis
Cooling Fan (CHAFAN1,CHAFAN2) paragraph on page 34 for
more details.
SY-KT600 DRAGON Plus
9