Connecting The Monitor To The Line Voltage; Connecting The Pc To The Line Voltage - Fujitsu Siemens Computers JETSON Operating Manual

Preparation for use and operation

Connecting the monitor to the line voltage

Ê
Prepare the monitor as described in the Operating Manual for the monitor.
Ê
Plug the data cable of the monitor into the monitor port of the system unit.
Ê
Depending on the connector, plug the monitor power cable into either the system unit (1) or the
grounded power outlet (2).
You may only plug the monitor power cable into the monitor connector if the rated current
!
of the monitor is less than 1.5 A (230 V) or 3 A (115 V). The rated current for the monitor
is also given on the monitor itself and in the Operating Manual for the monitor.

Connecting the PC to the line voltage

Ê
Check the rated voltage.
The value shown or the value marked with an arrow must agree with the local line voltage:
!
115 = 100 V to 125 V
12
Connecting the PC to the line voltage
1
230 = 200 V to 240 V
2
A26361-K619-Z100-1-7619