Table of Contents
Advertisement
How to install the hob:
Overall dimensions of the hob:
Width: 580 mm Depth: 510 mm
Worktop cut-out dimensions:
Width: 560 mm Depth: 490 mm
1. Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker hood
to ensure that you will have the required clearance. The cut-out (Fig.5) shows a 60mm gap from the wall to the cut-out edge.
The distance from the hob, when fitted, to the back wall is 50mm.
If a splashback/worktop upstand is to be fitted, take this into account when cutting the hole. The minimum distance that the
hob should be positioned away from the rear wall or splashback is 50mm.
2. Fix the foam seal underneath the appliance by following the outline of the worktop upon which the hob will rest
This ensures an airtight seal with the worktop. Do not use silicone type sealant.
50mm
25mm
50mm
Fig.3
Fig.5
6mm
500 x 10
580/770
580
64
560 / 750
A
Fig.4
510
490
560
50
600mm minimum
(650mm recommended)
50
11
Advertisement
Table of Contents
