Table of Contents
Advertisement
Care and Maintenance
Always disconnect the appliance from the power supply before undertaking any cleaning or maintenance.
Important:
•
Steam cleaners must not be used when cleaning this appliance.
•
You should use a non-abrasive cleaner to clean the hob top. Any abrasive cleaner (including Cif) will scratch the surface and
could erase the control panel markings.
•
Sugar and starch can cause permanent damage to the surface of the hob. Wipe away any spillages immediatly.
Types of residues
Light
Accumulated baked-on stains/
dirt, sugar spills or melted plastics
Rings and hard water residues
Shiny metallic streaks
9
If your hob is not working:
1. Check that the zone is switched on.
2. Check that the mains supply has not been switched off.
3. Check that the fuse in the spur has not blown.
4. Check the hob is configured correctly (see page 13)
In the event of a fault with the hob, please advise CDA Customer Care of any fault code shown on the display
Contact CDA Customer Care
A : Customer Care Department, The CDA Group Ltd, Harby Road, Langar, Nottinghamshire, NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
8
Clean with
Cleaning sponge and soft cloth
Cleaning sponge or glass scraper
and soft cloth
White vinegar and soft cloth
Cleaning agent for vitroceramic
glass etc.) Slow boiling, e.g.
spaghetti, soups, stews, potatoes
fast frying steaks
Cleaning advice
Wipe over the zone to be cleaned with a sponge and hot
water, and then wipe off with a soft dry cloth.
Wipe over the zone to be cleaned with a sponge and hot
water, using a ceramic scraper to remove any large marks
or stains and then wipe off with a soft dry cloth.
Pour a small amount of warm white vinegar onto the stain,
leave it to stand, and then wipe off with a soft dry cloth.
Use specialist vitroceramic glass cleaner (preferably one
with silicone for its protective properties)
Advertisement
Table of Contents
