Toshiba RAS-M10PKVP-E Service Manual page 139

No. Part name
Attachment
TG sensor
18
TGe: Black
Mount these sensors on the directly arranged
TGd: Blue part of the header connecting pipe at gas side
TGc: Green so that the cabinet turns toward the front side
TGb: Red and the sensors turn toward upper cabinet.
TGa: Yellow
NOTE)
When mounting the sensors, check paint color
of the sensor lead tube part and the pipe color.
Mount the sensors to the position of same color.
Detail G
Sensor wiring • Using bundling band, bind PMV coil
19
process (Black to Yellow) with Tga to Tge.
• For Td sensor, bind the case thermo and
reactor lead by bundling band.
Bundling band Bundling band Bundling band
PMV coil (Black to Yellow) PMV coil (Black to Yellow) PMV coil (Black to Yellow)
TGa to TGe sensors TGa to TGe sensors TGa to TGe sensors
Bundling band Bundling band Bundling band
Td sensor Td sensor Td sensor
Case thermo Case thermo Case thermo
Reactor lead Reactor lead Reactor lead
NOTE)
Using the bundling band being on the market,
be sure to bind the position which was bound.
Procedure
TGe: Black
TGd: Blue
TGc: Green
TGb: Red
TGa: Yellow
Pass TG sensor through the Pass TG sensor through the Pass TG sensor through the
upper side of connecting pipe of upper side of connecting pipe of upper side of connecting pipe of
PMV unit (Black) and then bind PMV unit (Black) and then bind PMV unit (Black) and then bind
it with lead wire of PMV coil. it with lead wire of PMV coil. it with lead wire of PMV coil.
– 139 –
Remarks
Detail G
NOTE)
At working time (finish time), be
sure not to damage the cover of
the sensor lead wire with edge of
sheet metal, etc.
If the cover of the sensor lead
wire is damaged, it is dangerous
because an electric shock or fire
may be caused.
NOTE)
After replacing of parts, check
the sensors are mounted at the
specified positions.
If there are incorrect mounted
positions, control of the product
does not operate correctly and a
trouble may be caused.