Toshiba RAS-M10PKVP-E Service Manual page 132

No. Part name
DI P .C. board 7) Remove the earth wire of DI P .C. board.
6
(Continued)
8) Take off fixing screws for DI P .C. board.
9) Remove DI P .C. board. (3 supporters)
NOTE)
Be careful that DI P .C. board is difficult to be
taken out by radiating grease for the heat sink.
10) Mount a new DI P .C. board.
NOTE)
• Take note that the compressor lead V:
• Be sure not to forget to attach the Sub
Procedure
(Truss head B tight screw Ø4 × 6, 1 pc.).
(Flange nut to fix element Ø3 × 16, 7 pcs.:
Pan head S tight screw to fix P .C. board
Ø3 × 20, 1 pc.)
CN201 (white) and the reactor lead CN05,
CN06 are correctly attached.
(For the compressor lead, the transparent
sleeve is attached to the circular terminal,
and for the reactor lead, the transparent
sleeve is not attached to the circular terminal.)
heat sink and also the rediating sheet.
(If you apply a little amount of radiating
grease beforehand to the rear side of the
insulation sheet, the attaching work to the
heat sink will become easy.)
– 132 –
Remarks
Fixing screws Earth screw
for element
(7 positions)
DI P.C. board Supporters
fixing screw (3 positions)
DI P.C. board Radiating grease
Sub heat sink Rediating sheet