Toshiba RAS-M10PKVP-E Service Manual page 138

No. Part name
Attachment
TE sensor
14
(Outdoor heat
Mount TE sensor on the straight part of the
exchange condenser discharge port pipe so that the lead
temperature) wire directs upward and the sensor directs the
liquid store tank.
Detail C
Attachment
TS sensor
15
(Suction
Insert TS sensor into the sensor holder welded
temperature)
to the suction pipe and then mount it.
Detail D
Attachment
TD sensor
16
(Discharge
Mount TD sensor on the straight part of the
temperature) discharge pipe so that the lead wire directs
upward and the sensor directs upward of the
cabinet.
Detail E
Attachment
TO sensor
17
(Outside
Insert TO sensor holder claw into the heat
temperature)
exchange terminal block hole and then mount it.
Detail F
Procedure
Heat exchange TO sensor
terminal block hole holder
– 138 –
Remarks
Detail F
Detail C
Detail D
Detail E
NOTE
At working time (finish time), be
sure not to damage the cover of
the sensor lead wire with edge of
sheet metal, etc.
If the cover of the sensor lead wire
is damaged, it is dangerous
because an electric shock or fire
may be caused.
NOTE
After replacing of parts, check the
sensors are mounted at the
specified positions.
If there are incorrect mounted
positions, control of the product
does not operate correctly and a
trouble may be caused.