Dynacord PM 502 User Manual page 5

PM 502
15. To ensure the device is completely free of voltage, unplug the device from the power
16. When installing the device, ensure that the plug is freely accessible.
17. Do not place any sources of open flame, such as lit candles, on top of the device.
18. This PROTECTION CLASS I device must be connected to a MAINS socket with a safety
Caution!
Use only manufacturer-approved carts, stands, brackets, or tables that you acquired together
with the device. When using carts to move the device, make sure the transported equipment
and the cart itself cannot tip over or cause injury or material damage.
IMPORTANT SERVICE INFORMATION
Caution!
This service information is for use by qualified service personnel only. To avoid the risk of
!
electric shock, do not perform any maintenance work that is not described in the operating
instructions unless you are qualified to do so. Have all service work and repairs performed by
a trained customer service technician.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Danger!
SAFETY COMPONENT (MUST BE REPLACED BY ORIGINAL PART)
Notice!
Due to line current harmonics, we recommend that you contact your supply authority before
connection.
Bosch Sicherheitssysteme GmbH
supply.
ground connection.
Repair work on the device must comply with the safety standards specified in EN 60065
(VDE 0860).
A mains isolating transformer must be used during any work for which the opened device
is connected to and operated with mains voltage.
The device must be free of any voltage before performing any alterations with upgrade
sets, switching the mains voltage, or performing any other modifications.
The minimum distance between voltage-carrying parts and metal parts that can be
touched (such as the metal housing) or between mains poles is 3 mm, and must be
observed at all times.
The minimum distance between voltage-carrying parts and circuit parts that are not
connected to the mains (secondary) is 6 mm, and must be observed at all times.
Special components that are marked with the safety symbol in the circuit diagram (note)
must only be replaced with original parts.
Unauthorized changes to the circuitry are prohibited.
The protective measures issued by the relevant trade organizations and applicable at the
place of repair must be observed. This includes the properties and configuration of the
workplace.
Observe the guidelines with respect to handling MOS components.
User manual
Safety | en 5
15-May-14 | 02 | F01U297804