Display; Menu - Dynacord PM 502 User Manual

26 en | Operation
7.8

Display

The PM 502 includes a back-lit LC-display.
Home screen
The home screen appears after switching the PM 502 on. After a few seconds the currently
selected effect (number and name) is displayed. If effect parameters have been edited, an "E"
is indicated next to the preset number. Turn the FX/PARAMETER rotary control to select
another effect.
In the lower part of the display settings of the channels MASTER A, MASTER B and AUX are
indicated, please refer to following table.
Icon
/MIC
POST
M
DLY
MAS. A PRE or MAX. A POST
Equalizer control icon
EQ
LIM
Speaker icon
Table 7.1: Indicators in home screen
If the screensaver is activated the Dynacord logo and the device name (assigned in the DEVICE
SETUP menu) is indicated after some time.
7.8.1

Menu

Press the MENU/ENTER rotary encoder to access the menu.
In menu the MENU/ENTER rotary encoder is used for navigation and for selecting and editing
parameters. Turn the MENU/ENTER rotary encoder to the left or to the right to move the
cursor in the menu. Press the MENU/ENTER rotary encoder to select the highlighted menu
item. The value is shown in inverse font and can be edited by turning the MENU/ENTER rotary
encoder. Press the MENU/ENTER rotary encoder again to apply the edited parameter value.
Following table lists the content of the menu.
15-May-14 | 02 | F01U297804
Description
LO CUT in menu MIC PROCESSING is activated.
The master routing of channel B is set to Post.
The channel is set to Mono.
The delay of the channel is activated.
Indicates the AUX Mode setting of the AUX channel.
The hardware equalizer controls are used to edit the
equalizer settings of this channel.
The equalizer setting of the channel is not set to flat.
The threshold of the output limiter has been edited.
Indicates the Amp Routing. If a Dual Amp Routing is
selected speakers for output channel 1 or 2 are indicated.
User manual
PM 502
Bosch Sicherheitssysteme GmbH