Locking - Dynacord PM 502 User Manual

18 en | Configuration
Setting
AUX-Bus
MAS A Pre
MAS A Post
Table 6.3: AUX modes
6.6

Locking

The PM 502 allows locking certain features or parameter settings in the menu. A four digit PIN
is used to lock or unlock the device. You can use one of three predefined locking levels or
select manually which parts of the menu should be locked, please refer to the following table
for details.
Menu
FX selection in home
screen
EDIT FX
AUDIO PLAYER
MIC PROCESSING
SPEAKER PROC
MASTER A EQ
MASTER B EQ
AUX EQ
MASTER ROUTING
OUTPUT SETTINGS
DEVICE SETUP 1
15-May-14 | 02 | F01U297804
Signal at AUX OUT
AUX
Pre Master A summed
Post Master A summed
Lock Mode
Level 1 Level 2
-
-
-
-
-
-
-
-
-
X
-
User manual
Description
This is the default AUX mode, the signal of the AUX
bus is present at the AUX OUT output. This mode
is mainly used for monitoring. AUX is especially
preferable when monitoring and master mix need
to be completely different from each other, e.g.
when the volume setting of particular musical
instruments or vocals needs to be higher or lower
than in the master mix.
The summed MASTER A signal is present at the
AUX OUT output. The signal is tapped pre MASTER
A volume control and therefore not affected by the
MASTER A control's setting.
The summed MASTER A signal is present at the
AUX OUT output. The signal is tapped post
MASTER A volume control and therefore affected
by the MASTER A control's setting.
Level 3 Custom
- - -
- X 1. Select the Lock Mode
"Custom" in the DEVICE
- -
SETUP menu.
- X
2. Activate the key icon of all
menus to be locked.
- X
3. Enter the PIN in the
X X
DEVICE SETUP menu to
lock all menus selected in
- X
step 2.
- X
X X
X X
X X
PM 502
Bosch Sicherheitssysteme GmbH