Scan Edges Programming - Icom IC-R6 Instruction Manual

Scan edges programming

Scan edges can be programmed in the same manner as
memory channels. Scan edges are programmed into scan
edge memory channels, 00A/00B to 24A/24B.
q Push [V/M] to select the VFO mode.
w Set a desired frequency:
Push [BAND] to select a desired band.
Rotate [DIAL] to set a desired frequency.
Set other data
(e.g. offset frequency, duplex direction, tone
, if desired.
squelch, etc.)
e Hold down [S.MW](V/M) for 1 second to enter the select
memory write mode.
• 1 short and 1 long beep sounds.
• The " " icon and memory channel number blink.
[EXAMPLE]: Programming 145.370 MHz into scan edge channel 03A (a blank channel).
The VFO mode
Hold down for 1 sec.
Enter the select memory write mode.
r Rotate [DIAL] to select a desired programmed scan edge
channel from 00A to 24A.
t Hold down [S.MW](V/M) for 1 second.
• 3 beeps sound
• The matched "B" channel is automatically selected when hold-
ing down [S.MW](V/M) after programming.
y To program a frequency for the other pair of scan edges,
00B or 24B, repeat steps w and r.
• If the same frequency is programmed into a pair of scan edges,
programmed scan will not function.
Rotate to select channel 03A.
Hold down for 1 sec. to program.
Return to the VFO mode.
SCAN OPERATION
6
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
30