Search Edges Programming - Icom IC-RX7 Instruction Manual

6
SEARCH AND SCAN OPERATIONS

■ Search edges programming

Search edges programming can be stored frequency edges,
receiving mode, tuning steps, attenuator ON/OFF and
search name. But other items of the frequencies are not nec-
essary to program. In this case, settings of each frequency
band are used to the search.
q Enter "PROGRAM SEARCH" in SEARCH menu.
MENU ➪ SEARCH ➪ PROGRAM SEARCH
(Push [MENU
• Search menu can also be entered by pushing and holding
[SEARCH] for 1 sec.
• Program number selection screen appears.
w Push [r] or [s] several times to select the desired pro-
gram number, then push [ENT MW] to enter the program.
NO. MENU
DIAL
CLR ENT
SQL MW
1 2 3
HOLD V
4 5 6
SCAN
7 8 9
SEARCH
.
0 SKIP
ATT
30
]), (Push [r]/[s], then push [ENT MW].)
MENU
ENT
Push
MW
e Push [s] once to select "EDIT," then push [ENT MW] (or
[w]).
r Set the desired edge frequencies either "LOW" or "HIGH."
• Other items cannot be programmed until these frequencies are
input.
LOW:/HIGH:
q Push [ENT MW] (or [w]) to enter the frequency input.
w Edit the desired frequency with keypad (pgs. 20, 21).
ENT
MW
e Push [r] or [s] to select another edge, then edit dif-
ferent frequency.