Scan Edges Programming - Icom IC-R20 Instruction Manual

■ Scan edges programming

Scan edges can be programmed in the same manner as
memory channels. Scan edges are programmed into scan
edges, 00A/00B to 24A/24B, in memory channels.
q Push [VFO MHz] to select VFO mode.
w Set the desired frequency:
➥ Select the desired band with [BAND].
➥ Set the desired frequency with [R-DIAL].
➥ Set other data
(e.g. offset frequency, duplex direction, tone
, if desired.
squelch, etc.)
ePush [MR S.MW] for 1 sec. to select select memory write
condition.
• 1 short and 1 long beeps sound.
• "µ µ
" indicator blinks.
rRotate [R-DIAL] to select the desired programmed scan
edge channel from 00A to 24A.
[EXAMPLE]: Programming 145.300 MHz into scan edges 03A.
MR
Push
S.MW
TSQL TSQL AFC
-DUP -DUP
ANL
MODE FM
145 300
PSKIP
√ µ 001
for 1 sec.
Rotate
FM FM
146.010 ---------------- ----------------
µ
. 001 001
-BANK BANK-:---- :---- -BANK BANK-:----
-BNAME: -BNAME: -BNAME: -BNAME:
-MNAME: MNAME: -MNAME: MNAME:
-SKIP SKIP-:OFF :OFF -SKIP SKIP-:OFF
>CLEAR CLEAR >CLEAR CLEAR
t Push [MR S.MW] for 1 sec.
• 3 beeps sound
• The other scan edge channel "B," 00B to 24B, automatically se-
lected when continuing to push [MR S.MW] after programming.
yTo program a frequency for the other pair of scan edges,
00B to 24B, repeat steps w and r.
• If the same frequency is programmed into a pair of scan edges,
programmed scan will not function.
MR
Push for 1 sec.
S.MW
TSQL TSQL
-DUP -DUP
ANL
MODE FM
145 300
µ
. 03A 03A
:----
√
:OFF
SCAN OPERATION
[R-DIAL]
MR
S.MW
AFC TSQL TSQL
-DUP -DUP
ANL
MODE FM
145 300
PSKIP PSKIP
µ 03A √ µ 020
7
7
AFC
36