Data Cloning - Icom IC-R6 Instruction Manual

10
OTHER FUNCTIONS

Data cloning

Cloning allows you to quickly and easily transfer the pro-
grammed contents from one receiver to another; or data
from a personal computer to a receiver, using the optional
CS-R6
CLONING SOFTWARE
D Cloning between receivers
q Connect the OPC-474 cloning cable to the [SP] jack of the
master and sub-receivers.
• The master receiver is used to send data to the sub-receiver.
to [SP]
Master
receiver
NOTE: DO NOT push any key on the sub-receiver during
cloning. This will cause a cloning error.
57
.
to [SP]
Sub
receiver
w While holding down [V/M], turn only the master receiver
power ON, to enter the cloning mode
power ON only for sub-receiver)
Master receiver
e Push [SQL] on the master receiver.
• The receiver displays the following.
Master receiver display
During cloning
After cloning
r
When cloning is finished, turn power OFF, then ON to exit
the cloning mode.
(master receiver only—
.
"CLONE" and "m" appear
when entered the cloning
mode.
Sub-receiver display