6
SCAN OPERATION
■ Scan edges programming
Scan edges can be programmed in the same manner as
memory channels. Scan edges are programmed into scan
edges, 0A/0B to 49A/49B, in memory channels.
q Push [V/MHz•SCAN] to select VFO mode.
w Set the edge frequency of the desired frequency range:
➥ Set the frequency using [DIAL].
➥ Set other data
e Push [S.MW•MW].
• "!" indicator and channel number blink.
r Rotate [DIAL] to select one of scan edge channel, 0A to
49A.
[EXAMPLE]: Programming 144.000 MHz into scan edge 1A.
Push
Rotate
27
, if desired.
(e.g. tone squelch, etc.)
Rotate
for setting frequency, etc.
Push
"
"
Beep
"
Beep
"
Beep
"
t Push and hold [S.MW•MW] for 1 sec. to program.
• 3 beeps sound and VFO mode is automatically selected.
• Scan edge 0B to 49B is automatically selected when continuing
to push [S.MW•MW] after programming.
y To program a frequency for the other pair of scan edges,
0B to 49B, repeat steps q to r.
• If the same frequency is programmed into a pair of scan edges,
programmed scan will not function.
Push
"
Beep
➠
for 1 sec. and continue to push
"
.
Beep