Saeco PRIMEA LINE 2007 Technical & Service Manual page 60

7.6 Gearmotor
Remove the casing (A) by
loosening the three screws.
To remove protection plate (C),
remove the indicated screws.
PRIMEA 2007 Chapter 07
REV. 00 - Mar. 07
Loosen the two screws and
remove the boiler valve (B).
The following are located inside the compartment
protected by the guard:
- Brew drive (A) with gears (B) and (C) for
transmission and timing of the dispensing
head;
- grounds drawer present microswitch (D);
- Dispensing head present microswitch (E);
- Microswitch (F) - dispensing head in home
position;
- Microswitch (G) - dispensing head in
dispensing position.
Remove the gear (C) that meshes with the brew
drive transmission shaft.
Remove the large gear (B).
Pull out the brew drive (A) complete with
transmission shaft (H).
7/22