Daewoo TVZ 1321 Service Manual page 18

Fig. 27- Tension Band Assem-
bly Removal (2)
Capstan Motor Removal
Remove three (3) screws and remove the capstan motor.
Fig. 29-Capstan Motor Removal
Idler Plate/Reel Table Removal
1. Remove one ¤ polywasher ¤ from the idler plate ¤Ł
and remove the idler plate ¤Łfrom the main base.
2. Remove the reel tables ¤Øand the two ¤Łpolysliders ¤Œ
from the deck mechanism.
Fig. 30- Idler Plate/Reel Table Removal
Fig. 28- Tension Band Assem-
bly Alignment With
Main Base
(Fig. 29)
(fig. 30)
FE Head Removal
Remove one (1) screw (1) and lift the FE head (2) from the
main base.
Fig. 31- FE Head Removal
Reel Gear Total Ass'y and Connect Plate
Removal
(fig. 32)
1. Turn the deck mechanism upside down and remove one
¤ polywasher ¤ .
2. Release the tab "B" of the main base and part the reel
gear total ass'y ¤Łfrom the main base.
3. Push the connect plate ¤Øto the left direction and sepa-
rate it from the main base.
NOTE :
• When removing the connect plate with the the F/L rack
installed, take care not to damage/bend the connect plate.
• When assembling or disassembling, take care not to get
oil or grease on the reel belt.
Fig. 32- Reel gear total ass'y and Connect Plate Removal
16
(fig. 31)