Daewoo TVZ 1321 Service Manual page 17

Fig. 23- L/C Bracket Assembly Alignment
Cam Gear, and F/L Rack Removal
1. Remove the cam gear
2. Remove the relay lever
3. Remove the F/L rack
NOTE :
When reassembling, align the assembly as shown in Fig.
23 & 24.
Fig. 24- Cam Gear/F/L Rack Alignment
S/T Main & Sub Brakes Removal
1. Unhook the main brake spring
lever .
2. Disconnect the main brake lever assembly
main brake lever from the main base
3. Unhook the s sub brake spring
and disconnect the s sub brake lever assembly
the main base .
4. Unlook the T sub brake spring
and disconnect the T sub brake lever assembly
the main base .
(fig. 22)
form the deck mechanism.
from the main base .
from the deck mechanism.
(Fig. 25)
from the T main brake
.
from the main base
from the main base
Fig. 25- Main Plate Removal
Tension Band Assembly Removal
1. Remove the tension spring
(Fig. 26)
2. Turn the deck mechanism upside down (fig. 27) is facing
down (fig. 27)
NOTE :
• After reassembling, adjust the position of the tension pole
as shown in fig. 28.
• Avoid getting grease or oil on the felt section of the band
brake.
and T
from
from
Fig. 26- Tension Band Assembly Removal (1)
15
(Fig. 26, 27)
from the main base