Extended Menu; Items In The Extended Menu - Sony DVCAM DSR-70A Operating Instructions Manual

Extended Menu

Items in the Extended Menu

The extended menu contains the following items.
In the Settings column of the table, the factory default
settings are underlined.
Item number Item name
101 SELECTION FOR
SEARCH DIAL
ENABLE
102 MAXIMUM TAPE
SPEED
Sub-item
1 SHUTTLE
2 F.FWD/REW
105 REFERENCE
SYSTEM ALARM
107 REC INHIBIT
LAMP FLASHING
108 AUTO EE
SELECT
109 FORCED EE
WHEN TAPE
UNTHREAD
Menu items in the 100s, relating to the control panels
Settings
Select how the unit enters the search mode.
DIAL: Turning the jog or shuttle dial switches to search mode at all times except during
recording/editing.
KEY: The search button must be pressed to switch to search mode.
Specify the maximum tape speed in REW (rewind) mode.
Specify the maximum tape speed in search mode (shuttle).
X16: Maximum 16 times normal
X32 : Maximum 32 times normal
X60: Maximum 60 times normal
Specify the maximum tape speed in F.FWD/REW mode.
X32: Maximum 32 times normal
X60: Maximum 60 times normal
X85 : Maximum 85 times normal
MAX: No maximum tape speed is specified.
Note
When this item is set to MAX, the playback video signal is muted.
Select whether or not to display alarm messages concerning the reference video signal.
ON: Flash the STOP button and display an alarm message.
LIMIT: Flash the STOP button and display an alarm message only either when the unit
is in recording mode or E-E mode or when editing operation is being carried out.
OFF: No alarm messages.
Select whether or not to flash the REC INHI indicator when recording is prevented
though the REC INHI switch on the control panel is set to OFF.
OFF: Light the REC INHI indicator.
ON: Flash the REC INHI indicator.
When a cassette is inserted and the PB/EE item in the sub LCD menu general settings
page is set to PB/EE, select the operation modes in which input video and audio signals
are automatically handled in E-E mode.
S/F/R: In STOP/F FWD (fast-forward)/REW (rewind) modes
STOP: In STOP mode
During tape threading and unthreading, and when no cassette is inserted, select
whether the PB/EE item of the sub LCD menu general settings page controls the output
signal PB/EE setting.
ON: No control (the signal is always an E-E signal).
OFF: Control.
(Continued)
109
Chapter 7 Setup Menu