Sony DVCAM DSR-70A Operating Instructions Manual page 144

Specifications
Video performance
Band width Composite (DSR-70A):
30 Hz to 4.2 MHz ±1.0 dB (Y)
Composite (DSR-70AP):
25 Hz to 4.8 MHz ±1.0 dB (Y)
S-Video (DSR-70A):
30 Hz to 5.0 MHz ±1.0dB (Y),
5.75 MHz +1.0/–3.0 dB (Y) (TM)
S-Video (DSR-70AP):
25 Hz to 5.0 MHz ±1.0dB (Y),
5.5 MHz +1.0/–2.0 dB (Y),
5.75 MHz +1.0/–3.0 dB (Y) (TM)
Component (DSR-70A):
30 Hz to 5.0 MHz ±1.0 dB (Y),
5.5 MHz +1.0/–2.0 dB (Y),
5.75 MHz +0/–3.0 dB (Y) (TM),
30 Hz to 1.3 MHz ±1.0 dB (C),
1.5 MHz +1.0/–5.0 dB (C)
Component (DSR-70AP):
25 Hz to 5.0 MHz ±1.0 dB (Y),
5.5 MHz +1.0/–2.0 dB (Y),
5.75 MHz +1.0/–3.0 dB (Y)
(TM), 25 Hz to 1.5 MHz ±1.0 dB
(C), 2.0 MHz +1.0/–2.0 dB (C)
S/N Composite I/O (Y):
53 dB or more
S-Video I/O (Y): 55 dB or more
Component I/O (Y):
55 dB or more
Y/C delay 30 ns or less
K-factor 2.0% or less (K2T, KPB)
Processor adjustment range
Video level ±3 dB/–∞ to 3 dB selectable
Chroma level ±3 dB/–∞ to 3 dB selectable
Setup/Black level
±30 IRE/210 mV
Chroma phase ±30˚
Audio performance
Frequency response
2 ch (48 kHz/16 bit):
20 Hz to 20 kHz +0.5/–1.0 dB
4 ch (32 kHz/12 bit):
20 Hz to 14.5 kHz +0.5/–1.0 dB
Dynamic range 87 dB or more
Distortion 0.07% (48 kHz) or less
144
Appendixes
Input connectors
Digital input
DV IN/OUT (When using optional DSBK-140 or
DSBK-160A board)
6-pin IEEE1394 connector ×1
SDTI (QSDI) IN (When using optional DSBK-150
board)
BNC type ×1, SDTI (QSDI) format
(270Mbps)
SDI IN (When using optional DSBK-160A board)
BNC type ×1, SMPTE 259M
(DSR-70A)/ITU-R BT.656
(DSR-70AP), SDI format
(270Mbps)
Analog video input
BNC type ×2 (loop-through),
VIDEO INPUT
composite, 1.0 Vp-p, 75 Ω, sync
negative
REF. VIDEO IN BNC type ×2 (loop-through), black
burst, 0.286 Vp-p (DSR-70A) or
0.3 Vp-p (DSR-70AP), 75 Ω,
sync negative
DIN 4-pin ×1
S VIDEO IN
Y: 1.0 Vp-p, 75 Ω, sync negative
C: 0.286 Vp-p (DSR-70A) or
0.3 Vp-p (DSR-70AP), 75 Ω
(burst level)
Y/R–Y/B–Y (when using DSBK-170 Analog
Component Input/Output Board)
BNC type ×3 (with input/output
selection switch), component
video
Y: 1.0 Vp-p, 75 Ω, sync negative
R–Y: 0.7 Vp-p, 75 Ω (75% for
DSR -70A or 100% for DSR-
70AP)
B–Y: 0.7Vp-p, 75 Ω (75% for
DSR -70A or 100% for DSR-
70AP)
Analog audio input
XLR 3-pin (female) ×2
AUDIO INPUT
+4/0/–60 dBu, high impedance,
balanced
Timecode input
BNC type ×1, SMPTE (DSR-70A)/
TC IN
EBU (DSR-70AP)
0.5 to 18 Vp-p, 3.3 kΩ, unbalanced