Connections For Digitally Dubbing Signals In Dvcam Format (Optional Dsbk-140/150/160A Required) - Sony DVCAM DSR-70A Operating Instructions Manual

Connections for Digitally Dubbing Signals in
DVCAM Format
Required)
You can use this unit to digitally dub signals in
DVCAM format automatically from the beginning of
the tape to the end, through an i.LINK or SDTI(QSDI)
interface.
For information about how to carry out digital dubbing, see
"Digitally Dubbing Signals in DVCAM Format" (page 50).
Connecting two DSR-70A/70AP units using
Connecting two DSR-70A/70AP units using the SDTI(QSDI) interface (DSBK-150 SDTI (QSDI)
Input/Output Board)
DSR-70A/70AP (player)
Player settings
Switch
REMOTE/LOCAL switch
When connecting this unit with a DSR-60/60P/
80/80P/85/85P unit using the SDTI(QSDI)
interface (DSBK-150)
Replace the DSR-70A/70AP (player) shown in the
above diagram with a DSR-60/60P/80/80P/85/85P unit
and make the same connections as shown above.
The SDTI(QSDI) interface connector of the DSR-85/
85P/1500/1500P/1600/1600P/1800/1800P/2000/2000P
is marked "QSDI(OUTPUT)."
(Optional DSBK-140/150/160A
REMOTE
SDTI
(QSDI)
OUT
Setting
REMOTE
the i.LINK interface (DSBK-140 or DSBK-160A)
Make the same connections and settings as described
in the section "Connections for Cut Editing Using Two
DSR-70A/70AP Units" (page 120).
DSR-70A/70AP (recorder)
2
REMOTE
SDTI
(QSDI)
IN
1
1 75 Ω coaxial cable (not supplied)
2 RCC-5G/10G/30G 9-pin remote control
cable (length 5 m (16 ft)/10 m (33 ft)/30 m
(98 ft), not supplied)
Recorder settings
Switch
REMOTE/LOCAL switch
Chapter 8 Connections and Settings
Setting
LOCAL
131