Sony DVCAM DSR-70A Operating Instructions Manual page 28

Location and Function of Parts
Optional board/timecode/remote control/power input and output section
AUDIO INPUT
-60 0 +4dbu -60
CH-1 CH-2
AUDIO OUTPUT
1/3 2/4
Cable clamp
1 REMOTE (9-pin remote control) connector
(D-sub 9-pin)
When editing with two DSR-70A/70AP units, connect
this connector on each unit using a 9-pin remote
control cable (not supplied). When editing with this
unit and external equipment, connect the external
equipment.
2 TC IN (timecode input) connector (BNC type)
To record timecode from an external device, input the
timecode from the external device's timecode output
connector.
3 DC IN (external power input) connector (XLR
4-pin, male)
To power this unit with AC power, connect to the DC
output connector of the AC-550/550CE AC adaptor.
You can also connect a BP-90/90A Battery Pack using
the DC-210 Battery Adaptor.
Power supplied through this connector is used on a
priority basis even when you have connected a battery
pack or AC-DN2A/DN2B AC Adaptor to the battery
connector on the top panel.
For more information, see "Power Preparations" (page
31).
28
Chapter 1 Overview
VIDEO
OFF ON OFF ON
75Ω 75Ω
REF. INPUT OUTPUT
IN
1
0 +4dbu
2(SUPER)
REMOTE
OUT
S VIDEO
IN
MONITOR Y
IN OUT
OUT
AUDIO
R-Y B-Y
a) This illustration shows the DSR-70A/70AP fitted with the optional DSBK-170.
1 REMOTE connector
2 TC IN connector
DC IN
TC IN
3 DC IN connector
TC OUT
4 TC OUT connector
5 Optional interface board fitting port
4 TC OUT (timecode output) connector
(BNC type)
Outputs the following types of timecode, depending on
the VCR operating status.
During playback: The playback timecode
During recording: The timecode generated by the
internal timecode generator, or the timecode input
through the TC IN connector.
For details of the timecode output during recording, see
setup menu item 611 (page 114).
5 Optional interface board fitting port
Install any one of the following optional interface
boards here:
• DSBK-140 i.LINK/DV Input/Output Board
• DSBK-150 SDTI (QSDI) Input/Output Board
• DSBK-160A SDI/i.LINK/DV Input/Output Board
• DSBK-170 Analog Component Input/Output Board
The connectors provided by the optional boards are as
follows.
a)