Previewing Edit Results - Sony DVCAM DSR-70A Operating Instructions Manual

Setting Edit Points Selecting an Edit Mode
To cue up an edit point
Press and hold the recorder side or player side IN or
OUT button, and press the recorder or player
PREROLL button while holding the IN or OUT
button.
AUDIO IN
– +
TRIM
CLIP
LIST MARK
LINK
DELETE ENTRY SHIFT
IN OUT
The tape runs to the IN point or OUT point and stops.
To preroll the tape
Press the recorder side or player side PREROLL
button.
PREROLL button
82
Chapter 5 Editing
REC
PREROLL
INHI
PREROLL button
OUT button
IN button
REC
PREROLL
INHI
The tape runs to the preroll point, located in advance
of the edit start point by the specified amount of time,
and then stops.

Previewing Edit Results

When you finish setting the edit points, the PREVIEW
button flashes to indicate that you can conduct a
preview.
To conduct a preview, press the recorder side
PREVIEW button, turning it on.
PREVIEW
PREVIEW button
During the preview, you can see the video in the
recorder side LCD monitor and listen to the audio
through the recorder side speaker. The figure below
shows the video and audio signals which can be
monitored.
IN point
Recorder unit's Player unit's E-E
playback signals signals
After the preview, modify, delete, or reset edit points
as required.
For more information about modifying edit points, see
"Modifying Edit Points" (page 83).
To stop a preview
Press the STOP button on the recorder.
The tape stops when the button was pressed.
STANDBY STOP
x
STOP button
OUT point
Recorder unit's
playback signals