Setting Marker Display - Sony HDW-790 Operation Manual

Item Description
GAIN GAIN switch position L, M, H, or
0 dB
SHUTTER
Shutter mode OFF, ECS, SLS
1/60
WHITE BAL White balance automatic
adjustment memory, P (PRST), A,
B, PA, PB, or AB
5600K 5600K mode ON or OFF
ATW ATW ON or OFF
EXTENDER Extender ON or OFF
FILTER ND ND Types of the ND filter, 1, 2, 3,
or 4
FILTER CC CC Types of the CC filter, A, B, C,
or D
OVERRIDE ON or OFF when the reference
value of the auto iris adjustment is
other than the standard value
1) The SLS mode is effective only when an optional HKDW-905R
extension board is installed.
2) Depending on the frame frequency currently selected.
For details, see "4-2-1 Shutter Modes" on page 62.
7
Perform the settings for each item.
1 Turn the MENU knob to move the
item you want to set, then push the MENU knob.
b
The mark on the left of the selected item changes
to a z mark, and the z mark on the left of the
setting changes to a ? mark.
2 Turn the MENU knob to change the setting, then
push the MENU knob.
3 To continue setting other items, repeat steps 1 and
2.
8
To end the menu operation, set the MENU ON/OFF
switch to OFF.
When you change the settings only on the '!' LED
page
The '!' LED page is also registered in the USER menu.
You can access this page without opening the TOP page.
Open the USER menu by pressing the MENU ON/OFF
switch and display this page from the USER menu.

5-2-5 Setting Marker Display

The MARKER 1 page of the USER menu allows you to
switch the display of the center and safety zone markers on
or off and to select the area indicated by the safety zone
marker.
1)
,
2)
b
mark to the
MENU knob MENU ON/OFF switch
1
Set the MENU ON/OFF switch to ON.
The menu page accessed last appears on the
viewfinder screen.
2
Turn the MENU knob until the MARKER 1 page
appears, then push the MENU knob to select the page.
The current setting of each item appears on the right of
the item.
You can set the following items on the MARKER 1
page.
Item Description
MARKER When you do not want to display all
markers, set to OFF.
CENTER To display the center marker, set to ON.
CENTER Selects the type of center marker (1 to
MARK 4), when CENTER is set to ON.
SAFETY To display the safety zone, set to ON.
ZONE
SAFETY Selects the safety zone range (80%,
AREA 90%, 92.5% or 95%), when SAFETY
ZONE is set to ON.
ASPECT To display the aspect marker, set to ON.
ASPECT Selects the type (15:9, 14:9, 13:9, 4:3,
SELECT 1.85, 2.35) of the aspect marker.
ASPECT To make the areas out of the selected
aspect marker dimmer, set to ON.
1)
MASK
ASPECT Sets the mask level (0 to 8), when the
MASK LVL ASPECT MASK is set to ON.
100% To display the effective pixel area, set to
MARKER ON.
1) The ASPECT MASK item is for processing the signal to be output to
the viewfinder. When R, G, or B is selected for the OUTPUT
SELECT item from the menu, the masked video signal is output to
the TEST OUT connector.
Status Display on the Viewfinder Screen
CANCEL/PRST /
ESCAPE switch
87