Table of Contents
Advertisement
7-8 Adjusting the
Shoulder Pad Position
You can shift the shoulder pad from its center position
(factory setting) backward by up to 10 mm (3/8 inch) or
forward by up to 25 mm (1 inch). This adjustment helps
you get the best balance for shooting with the camcorder
on your shoulder.
1
Raise the lever in the center of the shoulder pad to
unlock the shoulder pad.
2
Slide the shoulder pad backward or forward until it is
in the most convenient position.
3
Bring down the lever to lock the shoulder pad in the
selected position.
7-9 Attaching the Rain
Cover (Not Supplied)
Attach the rain cover (part number 3-191-064-02) as
illustrated below. You can insert and remove cassette tapes,
operate various switches and controls, and mount the
camcorder on the tripod adaptor with the rain cover
attached.
When a shoulder
belt is not used,
cover the holes
on the rain cover
with caps.
Bottom
Shoulder pad
Adjusting the Shoulder Pad Position / Attaching the Rain Cover (Not Supplied)
Rear
Velcro tape
Remove the cap, and then pass the shoulder strap post
clearly through this hole on the rain cover.
Insert the viewfinder barrel here with the
eyecup out and fasten the drawstring around
the eyecup.
Drawstring
Velcro tape
When you use a
shoulder strap,
use these holes.
For details, see
the following
diagram.
Front
Drawstring
Velcro tape
129
Advertisement
Table of Contents
