Table of Contents
Advertisement
When an optional HDVF-C30W HD
Electronic Viewfinder is used
The HDVF-C30W is not equipped with a microphone
holder. Attach an optional microphone bracket (Part No.
A-8279-919-A) to the HDVF-C30W first, then attach the
supplied microphone.
1
Attach the microphone bracket (Part No. A-8279-919-
A) to the HDVF-C30W, using the 4 screws (+B2.6 x 6)
supplied with the microphone bracket.
Microphone bracket
(Part No. A-8279-919-A)
2
Loosen the viewfinder left-right positioning ring on
the camcorder, and engage the slide rail on the
viewfinder with the slide guide on the camcorder.
Viewfinder left-right
positioning ring
3
Position the viewfinder by sliding it from side to side,
and tighten the viewfinder left-right positioning ring
on the camcorder. Then connect the plug to the VF
connector on the camcorder.
124
Audio Input System
HDVF-C30W
Slide rail
Stopper
Slide guide
VF connector
Note
When an HDVF-C30W is connected, "NG" or "– –" is
displayed for EEPROM STATUS on the DEV STATUS
page (page 168) of the DIAGNOSIS menu. However, this
is not a malfunction.
7-5-2 Using an External Microphone
You can connect up to two external microphones using the
AUDIO IN CH1 and CH2 connectors.
Set the LINE / AES/EBU / MIC switch to MIC.
When using a condenser microphone that requires external
power (phantom power), set the +48 V/OFF switch to
+48 V.
If the microphone being used does not require external
power (dynamic microphone), set the +48 V/OFF switch
to OFF.
Plug
Advertisement
Table of Contents
