Selecting The Items For Which The '!' Led Is To Light - Sony HDW-790 Operation Manual

4
To end the menu operation, set the MENU ON/OFF
switch to OFF.
5-2-4 Selecting the Items for Which
the '!' LED is to Light
The '!' LED page of the OPERATION menu allows you to
select the items for which the '!' indicator is to light up on
the viewfinder screen. Also, the '!' LED STD page allows
you to select the lighting conditions.
MENU knob
1
Set the MENU ON/OFF switch to ON while holding
down the MENU knob.
The TOP menu appears.
2
Turn the MENU knob to move the
OPERATION, then push the MENU knob.
If this is the first time the OPERATION menu has been
displayed, the CONTENTS page of the OPERATION
menu appears.
If the menu has been used before, the page accessed
last appears.
3
If the CONTENTS page is displayed, push the MENU
knob once, then turn the MENU knob to move the
mark to '!' LED, then push the MENU knob again to
display the '!' LED page.
If a different page is displayed, turn the MENU knob
until the '!' LED page appears, then push the MENU
knob to select the page.
The current setting of each item appears on the right of
the item.
The following table shows operations under the
condition where '!' LED STD has been pre-adjusted at
the factory.
86
Status Display on the Viewfinder Screen
CANCEL/PRST /
ESCAPE switch
MENU ON/OFF switch
b
mark to
b
Item Contents
GAIN Lights when the gain is set to
anything but 0 dB.
SHUTTER Lights when the SHUTTER
selector is set to anything but
OFF.
WHITE BAL Lights when the WHITE BAL
switch is set to PRST.
5600K Lights when the 5600K mode is
set to ON.
ATW Lights when ATW is being used.
EXTENDER Lights when the lens extender is
used.
FILTER Lights when the FILTER selector
is set to anything but ND:1/CC:B.
OVERRIDE Lights when the reference value of
the auto iris adjustment is other
than the standard value.
4
Perform the settings for each item.
1 Turn the MENU knob to move
you want to set, then push the MENU knob.
b
The mark on the left of the selected item changes
to a z mark, and the z mark on the left of the
setting changes to a ? mark.
2 Turn the MENU knob to change the setting, then
push the MENU knob.
3 To continue setting other items, repeat steps 1 and
2.
You can change the criteria for whether the '!'
indicator lights or does not light on the '!' LED STD
page.
To change the criteria, go to step 5.
If you don't want to change the criteria, go to step 8.
5
b
Move the mark to the page number, then push the
MENU knob. Or when the
of the item, push the CANCEL/PRST / ESCAPE
switch down to ESCAPE.
6
Turn the MENU knob until the '!' LED STD page
appears, then push the MENU knob.
b
mark to the item
b
mark is located at the left