Surround Panel Installation - Travis Industries Flush Wood Plus Owner's Manual

12 Fireplace Insert Installation

Surround Panel Installation

8" Panels
10" Panels
12" Panels
FOR INSIDE FIT PANELS ONLY: the panels may be cut down to fit within the fireplace - see directions below.
Do not cut more than 4"
from each side panel.
•
Before installing the side panels, position the insert over the hearth (not inside the fireplace). You
may wish to place something under the insert to prevent scratching (cardboard). Install the side
panels following the directions below.
Emblem Installation (included with the face)
Secure the emblem to the right side panel with the two
nuts (included with the face).
© Travis Industries
Width
45-1/2"
49-1/2"
53-1/2"
The rheostat is mounted
into the side panel. It
requires 1/8" and 3/8"
diameter holes to be
drilled into the panel.
Position the rheostat a
minimum 3" away from
the insert.
Attach the surround panels with the 6 screws included with the fireplace insert.
HINT: Before installing the panels, pre-thread the holes in the side of the insert
(use the self-threading screws).
Run the power cord behind the surround panel
(cut the lock-tie holding it in place).
100-01269
(for qualified installers only)
Height
29-1/2"
31-1/2"
33-1/2"
Part#
96100346
96100347
96100348
7/16"
4" Min.
Run the
rheostat wires
behind the
surround panel
(cut the lock-tie
holding them in
place).
4110712