Jacuzzi J - 415 Owner's Manual page 25

4. Activate Jets Pumps
Turn on jet(s) pumps when adding chemicals in step 5
(see Section 11.2, page 56 to activate jets).
5. Add Start-Up Chemicals
Add the spa water chemicals as recommended by your authorized
Jacuzzi spa dealer. See Section titled "Water Quality Maintenance"
(page 82) for general guidance.
WARNING:
!
Never leave chemicals opened and accessible to anyone. Use
chemicals according to the vendors instructions. Always store
chemicals in a safe and/or locked location. Keep away from
and out of reach of children.
6. Establish A Stable Sanitizer Reading
Establish a stable sanitizer reading of no less than 1.0 ppm free
chlorine or 2.0 ppm bromine. To ensure healthy water conditions,
always maintain a constant sanitizer reading within the levels
recommended on the inside cover of this manual. If sanitizer levels
cannot be stabilized, perform the decontamination procedure steps
1-7 on the following page.
Note: The "Decontamination Procedure" should also be used after the
spa has been "Winterized" (Sec. 15.8, page 81) or has been sitting
without power for an extended period.
7. Set Spa To Heat
To warm spa water to a comfortable
temperature, follow these steps:
• The LCD display on the control panel
displays the actual temperature of the spa
water. Press either the UP or DOWN button
on the Navigational Quad Keypad to increase or decrease the water
temperature by 1 degree.
• The heater will turn off 1 degree above set temperature and turn on 1
degree below set temperature.
RISK OF POISONING OR DEATH.
J-400
UP
LEFT
DOWN
Page 19
1
SPLASH
RIGHT