4.3.
Installation Procedure
1. Unpack the FCS-1020 IP Network Camera package and verify that all the items listed in
the Chapter 2 are provided.
2. Connect the FCS-1020 IP Network Camera to your network by attached the network cable
to the UTP port of the IP Network Camera.
3. Connect the power adapter to the IP Network Camera and plug the power adapter to
outlet. The IP Network Camera will be powered on. When the IP Network Camera is ready,
the Ready LED will show orange color.
Note: It is highly recommended to use the power adapter shipped with the IP Network
Camera, do NOT use any other power adapter from any sources.
5.
Software Installation
Follow the simple steps below to run the Install Wizard to guide you quickly through the
Installation process. The following installation is implemented in Windows XP. The installation
procedures in Windows 98SE/Me/2000/Server 2003 are similar.
1. Insert the CD shipped along with the IP Network Camera into your CD-ROM drive. The
Autorun.exe program should be executed automatically. If not, run Autorun.exe manually
from "AutoRun" folder in the CD.
2. The Install Wizard will show four selections, select "Install Utility & Viewer" to install or
click "Exit" to install the program later.
Power Jack
5
LAN Port