Accent Lamp Light Replacement - Empire Comfort Systems DVLT series Installation Instructions And Owner's Manual

ACCENT LAMP LIGHT REPLACEMENT

DVTT ACCENT LAMP LIGHT REPLACEMENT
If in the event the lamp or lens needs to be replaced, follow the
instructions below:
1. Unplug the remote from the junction box or disconnect all power
to the fireplace.
2. Remove the 4 screws that secure the lens frame. This frame
retains the glass lens. The bulb can now be accessed.
IMPORTANT: Do not handle the lamp (bulb) with bare
fingers, protect with clean dry cloth.
NOTE: The lamp will pull straight out of the socket. When re-
installing, ensure integrity of gasket seal.
Replacement Bulbs
Replacement bulbs are available locally at most hardware, appliance
or building supply stores. Replace with a G9 (120V/25W) series
halogen bulb.
THE FIREBOX MUST BE SEALED.
Over-tightening the screws could break the lens.
"Light Leakage" from the upper area may be observed. The holes
in the lamp housing are necessary for ventilation and must not be
covered.
Figure 64 - Accent Lamp Wiring
31259-3-0114
120V EXTENSION
MODULE
FAN
JUNCTION BOX
Figure 65 - Accent Lamp Parts
LAMP
GASKET
GLASS
BEZEL
Page 55