Empire Comfort Systems DVLT series Installation Instructions And Owner's Manual page 31

Before you begin: If you are installing logs into the DVTT36 Model
then this fireplace is supplied with a set of 10 ceramic fiber logs. Do
not handle these logs with your bare hands. Always wear gloves to
prevent skin irritation from ceramic fibers. After handling logs, wash
your hands gently with soap and water to remove any traces of fiber.
The positioning of logs is critical to safe and clean operation of this
fireplace. Sooting and other problems may result if the logs are not
properly and firmly positioned in the fireplace.
1. Remove mesh screen if applicable.
2. Remove glass door from firebox.
3. Remove logs from bun.
4. Remove the plastic wire tie holding the grate to the burner.
Discard the plastic wire tie and set the grate aside.
5. Place liner bottom into firebox.
6. Place log grate into firebox. The front bar will butt-up against
the burner.
7. Place the Right Ember Bed Chunk (A) between the right front
and right rear legs of the log grate and resting on the liner
bottom.
8. Place the Left Ember Bed Chunk (B) between the left front
and rear legs of the log grate and resting on the liner bottom.
31259-3-0114
DVTT36 LOG PLACEMENT
9. Slide the Ember Bed Front (C) under the log grate. It will be
in front of the Left Ember Chunk (B) leaving an open space to
the right front of the log grate.
10. Place the Left Rear Log (E) on the rear bar of the log grate.
The slot and groove on the log will fit over the left two bars of
the log grate.
11. Place the Center Ember Chunk (H) onto the middle pin on
the burner and over the middle right bar of the log grate.
12. Place the Left Ember Chunk (I) on the left pin and over the
second log grate burner bar from the left and partially of the
middle left bar.
Page 31