Setting The Hostname; Configuring Radius Authentication; Enabling And Disabling The Ssh And Web Server; Enabling And Disabling The Gauntlet Security Appliance - RuggedCom RuggedRouter RX1000 User Manual

®
RuggedRouter User Guide

Setting The Hostname

The Set Hostname command sets the hostname, shown in shell prompts and Web
Management.

Configuring RADIUS Authentication

The Set RADIUS Authentication command configures the address of a RADIUS
server, if available.
The Hostname/IP and Port Number fields configures the server location.
The Shared Secret field configures the unique password used by this server.
The time Timeout field selects the maximal time to wait before trying the next server.
The entry, created for both LOGIN and PPP Login, can be changed from the web
interface.

Enabling And Disabling The SSH and Web Server

By default SSH and Web Management are enabled. The Disable SSH and Disable
Web Management commands allows these services to be disabled. The servers will
be immediately stopped. If access to the shell has been made through ssh the session
will continue, but no new sessions will be allowed.
Upon disabling the services, the titles in the main menu will change to Enable SSH
and Enable Web Management to reflect the disabled state. Enabling a service
automatically restarts it.

Enabling And Disabling The Gauntlet Security Appliance

The Gauntlet security Appliance requires a pass phrase unique to your network. This
menu will configure it.
28

Figure 5: RADIUS Server Configuration menu

Figure 6: Gauntlet Setup Menu

RuggedCom