Configuring The Firewall And Vpn; Route Based Virtual Private Networking - RuggedCom RuggedRouter RX1000 User Manual

Rate-Limit
User-Group
Some examples will illustrate the power of the rules file:
Rule Action
1 ACCEPT net:204.18.45.0/24 fw
2 DNAT
3 DNAT
4 ACCEPT fw
5 ACCEPT net:204.18.45.0/24 fw
1) This rule accepts traffic to the firewall itself from the 204.18.45.0/24 subnet. If the
default policy is to drop all requests from net to the firewall, this rule will only
traffic from the authorized subnet.
2) This rule forwards all ssh and http connection requests from the Internet to local
system 192.168.1.3.
3) This rule forwards http traffic from 204.18.45.0/24 (which was originally directed
to the firewall at 130.252.100.69) to the host at 192.168.1.3 in the local zone. If
the firewall supports another public IP address (e.g. 130.252.100.70), a similar rule
could map requests to another host.
4) and 5) These rules allow the firewall to issue icmp requests to the Internet and to
respond to icmp echo requests from the authorized subnet.
Rules are defined in the file /etc/shorewall/rules and are modified from the Firewall
Rules menu.

Configuring The Firewall And VPN

Route Based Virtual Private Networking

Begin configuration by creating local, network and vpn zones (all as zone type IPV4).
The openswan daemon will have created ipsecX interfaces which should be added to
the vpn zone in the interfaces menu.
The IPsec protocol operates on UDP port 500 and using protocols ah (Authentication
Header) and Encapsulating Security Payload (ESP) protocols. The firewall must
accept this traffic in order to allow IPsec. If the firewall serves as the VPN gateway,
add the following rules:
Action
ACCEPT
ACCEPT
ACCEPT
RuggedCom
A specification which allows the rate at which connections are
made to be limited.
A method of limiting outbound traffic from the firewall to a
specific user, group of users and a specific application.
Source-Zone Destination-Zone Protocol Dest-
net loc:192.168.1.3
net:204.18.45.0/24 loc:192.168.1.3
net
Source-Zone Destination-Zone Protocol Dest-Port
all fw
all fw
all fw
Chapter 13 - Configuring The Firewall
Source
Port -Port
tcp ssh, http
tcp http -
icmp
icmp 8
ah
esp
udp 500
Original-
Destination-IP
130.252.100.69
117