Leg Leveling System; Brick Installation - Heat & Glo TIARAII-BK-B Owner's Manual

E. Leg Leveling System
Thread Allen bolts through nuts until ush. The
Figure 8.12
Allen bolts and nuts are included in the component pack inside
the appliance rebox.
Slide assembled nuts and bolts into the slots on
Figure 8.13
the legs with the nuts on the bottom.
Use a 5/32 in. (4mm) Allen wrench to adjust legs
Figure 8.14
up and down to desired level.
F. Brick Installation
NOTE: The brick supplied with this appliance is NOT an
optional accessory. The brick must be installed for safe and
proper operation.
I nstall rear panel by placing it behind the log pins
Figure 8.15
ush and centered against back of rebox.
30
REAR PANEL
Heat & Glo • TIARA II-B • 7011-148 Rev. L • 6/14
Install left and right side panels. Fold tabs over
Figure 8.16
on left and right sides to hold panels in place.
TOP PANEL / BAFFLE
Install top panel/baffle prior to installing top
Figure 8.17
panel/baf e. Holding panel at an angle, place one end on
top of side panel and lift other end into place. Move left or
right until centered.
COMPLETED BRICK INSTALLATION
Complete brick installation.
Figure 8.18
NOTE: In the Commonwealth of Massachusetts, the
word damper shall be replaced with the words flue
restrictor.
TABS
TABS