Baffl E Installation/Adjustment; Leg Leveling System - Heat & Glo TIARAI-BK-C Owner's Manual

Figure 8.5 Remove rear access plate and gasket. Save the
screws.
Figure 8.6 Place cover plate and gasket over top vent and
attach with the eight screws removed in Figure 8.2.
Figure 8.7 Insert inner collar adapter to rear fl ue vent.
Figure 8.8
Install vent pipe adapter with gasket or high-temp
sealant to rear vent opening. Attach with screws removed
in Figure 8.5.
Place grille (without a hole) gently into the opening on top of
appliance. Part: RV-GRILLE-T1
30
D. Baffl e Installation/Adjustment
Rear plate
and gasket
Figure 8.9
right sides. Centering baffl e on retainers, ensure that the
dark painted bevelled edge and darker painted baffl e bottom
side faces toward the front viewing area of the fi rebox. Bend
the center tabs up to prevent the baffl e from sliding out.
E. Leg Leveling System
Figure 8.10
NOTE: Two Allen bolts and two nuts are included in the
component bag. Normally, only one is required on the leg
not touching the fl oor.
Figure 8.11
with the nuts on the bottom.
Figure 8.12
up and down to desired level.
Heat & Glo • TIARA I-C • 7066-100 Rev. D • 12/11
BAFFLE
BAFFLE RETAINERS
Position baffl e on top of baffl e retainers on left and
Thread Allen bolts through nuts until fl ush.
Slide assembled nuts and bolts into slots on legs
Use a 5/32 in. 4mm) Allen wrench to adjust legs